What is Max Grow ?
The most effective solutions are often the simplest. MAX GROW is an electronic water treatment system using multiple transmissions of radio frequencies in three different frequency bands simultaneously ( ULF/LW/MW ) to tackle the problems caused by saline water and water with high concentration of calcium carbonate ions commonly known as limescale.
- CUTTING EDGE ULF-MW-LW TECHNOLOGY ASSISTING MOTHER NATURE DELIVER ITS BEST
- TRANSFROM WATER & SOIL SALINITY INTO CROP PRODUCTIVITY AND QUALITY EXCELLENCE
- ALL DISSOLVED SALTS AND MINERAL BECOME PRECIOUS NUTRIENTS
- DISSOLUTION IS THE ONLY SOLUTION IN SALINITY
- THE FUTURE OF SALINE WATER IRRIGATION IS TODAY
MAX GROW is smart, simple and effective
It is very important to note that the system does not cause deterioration of the chemical composition of water, or any other alteration.
Installing “MAX GROW” does not require cutting water pipes or engineering skills. It can be installed by an unskilled person, as it is attached with high quality clamps which are placed on the pipe, wrapping the wires left and right -the antennas for the radio wave transmission- of the device using electrical adhesive tape. The device can also be mounted on a base or a wall close to the pipe. Since no alteration of the piping is required water pressure and water flow remain the same as before.
The electronic water treatment MAX GROW runs either on electricity 220Volts or using a rechargeable battery of 24 volts. The cost of power consumption is insignificant. The device is available from 1 inch pipe up to 12 inches, depending on the external size of the pipe. The system can be installed in iron, plastic or copper pipes. However, the use of copper pipe where the antennas – cable coils are placed is recommended due to the fact that copper has the lowest electrical resistance compared to other materials, enabling the energy from the radio waves transmitted, to pass through the pipe with the minimal possible losses.
Water quantity, water flow and speed are totally insignificant in relation to the selection of the type of the unit. MAX GROW does not require filters or any form of servicing. The device does not have any interchangeable parts and is accompanied with a five-year written warranty.
Because of its’ extremely low power consumption, a photovoltaic system can supply the energy required for MAX GROW to operate, if there is no alternative power supply nearby. The internal electronics of the device receive a protective process during production assembly for protection against extreme weather conditions as well as water ingress and can withstand temperatures from – 45 degrees Celcius to + 65 degrees.
MAX GROW can fully perform under heavy rain or even snow. All units from 2” up to 6” carry an IP65, one of the highest levels of water ingress protection for electronics. 1” units carry an IP57 protection level.
Basic principles of the innovative technology applied in Max Grow
MAX GROW increases the level of solvent capability water has, in order to dissolve all the existing deposits, the ionic bonds have created. This is achieved by transmitting in continuously changing frequencies, radio waves. By this transmission the energy of the ions is increased, because of the electric energy being transported through the radio waves into water. The charged ions become powerful enough to charge the ions that have created the deposits in irrigation pipelines, boilers, cooling towers etc. The system transmits radio waves in constantly variable frequencies which are programmed automatically, virtually every tenth of a second from the device itself based on a mathematic algorithm. This is the competitive advantage of MAX GROW advanced electronic water treatment system, compared to any other water treatment device that exists on the market. It is worth mentioning that the technology of radio waves does not have any relation to magnetic fields.
MAX GROW system’s powerful advanced electronics transmit radio waves to both left and right side in different frequencies at the same time and in up to 30 meters distance to each side. Water is already being pre-processed and its ions are charged with energy before it reaches the spot where the device is installed. Charged ions from MAX GROW remain in this form for up to 72 hours, although we have to mention that as time passes the desirable charge of the ions starts to fade. In order to avoid this phenomenon our company strongly suggests that MAX GROW should not be installed before water tanks or any other place that water may remain standstill.
CALCIUM CARBONATE IONS ( photos taken by an electronic microscope, ions magnified x500 )
WITHOUT MAX GROW
WITH MAX GROW
Acicular aragonite (needles)
Max Grow assisting mother nature to perform at its best
The major element for plant nutrition and growth is water and soil. Water as well as soil, include minerals and nourishing ingredients, which are vital for any plant and crop growth. Some of them, due to nature forces, tend to create various types of formations. Calcium is an element which causes these formations and although it is essential for a plant’s growth, it is united with carbonate ions, creating calcium carbonate. Calcium carbonate appears in any surface which is dampened by water such as water pipes, irrigation systems and even the soil itself. The formation of calcium carbonate is trapping many other essential elements such as magnesium and Iron. The first indication of scale formation is visual in water pipelines and irrigation systems.
Secondly salts are deposited on the soil, forming circular white marks around the plants’ routes. This phenomenon leads to soil hardening preventing water, nutrients and fertilizers to pass through it and reach the capillary vessels of the plant. Furthermore, soil hardening, decreases the level of evapotranspiration. Under these circumstances, if any amount of water reaches the plants routes, faces tremendous difficulty in reaching the semi-permeable films of the cells.
For many years now, the farming industry has been trying to overcome all these difficulties, caused by the existence of calcium carbonate and sodium in water. The most common, well-known and acceptable solution until now has been the use of chemicals, which are produced by big chemical companies, using hydrochloric acid as base. Hydrochloric acid is extremely harmful for any plant and for humans as well.
The technological innovation of MAX GROW is based on radio wave transmission and is very similar with the technology already used in medicine to treat kidney stones without surgery (lithotripsy). This particular technology does not have any relation with magnets, electromagnets, magnetic fields, or any other method that affects ions by changing their polarity using magnetism.
It is simply an extend and a practical application of the pulsed power and the stimulation of plant growth by electricity, which is being transported using radio waves in constantly altering frequencies. Research in scientific terms around these two topics has begun in 1910 and has grown into more specific and scientifically proved experiments throughout the years that have shown significant results in plant growth.
Some of these researches implemented by scientists and institutions are extremely narrowed and specified referring to the stimulation of the plant cell division, the effect of nanosecond pulsed electric field and the bioelectricity and its’ positive effects in plant growth. All of the above researches have been published in scientific magazines and on the internet and are accepted by the majority of the scientific community from electrical engineers to soil scientists.
Some of the publications that have commended regarding the positive attributes of electric stimulation applied in plants are the following:
- Electrical stimulation and its effects on growth and ion accumulation in tomato plants
J. D. Black, F. R. Forsyth, D. S. Fensom, R. B. Ross
Canadian Journal of Botany, 1971, 49(10): 1809-1815, 10.1139/b71-2
- Electricity may play role in plant growth
New York Times Published: April 9, 1985
- Electrophysiology of Woody Plants
Luis A. Gurovich, Universidad Católica de Chile, Chile
- Electrofusion and Electroporation of Plants
Sally L. Van Wert, James A. Saunders
SARL, Plant Sciences Institute, United States Department of Agriculture,
Agricultural Research Service, Beltsville, Maryland 20705, November 20, 1991
- Electrofusion principles and applications.
Bates GW, Saunders JA, Sowers AE (1987In AE Sowers, ed, Cell Fusion. Plenum
Press, New York,
- Calcium: A Central Regulator of Plant Growth and Development
Peter K. Hepler, American Society of Plant Biologists, The Plant Cell,
August 2005 vol. 17 no. 8 2142-2155
- Plant protoplasts: status and biotechnological perspectives
Michael R. Daveya, Paul Anthonya, J. Brian Powera, Kenneth C. Loweb
Plant Sciences Division, School of Biosciences, University of Nottingham,
One of the thousands of scientific studies referring to the minimization of
crop growth among a plethora of other problems in saline conditions
Why is calcium carbonate insoluble in water ?
In order for an ionic substance to dissolve in water, its ions have to be solvated by the water molecules and the ions separated in water have to have a lower energy volume compared to the energy they have when they are in solid form. Calcium carbonate is insoluble in water because it is extremely stable as a solid and water does not have sufficient solvating capability to cause the separation between ions and come into solution. Both calcium and carbonate do have salts which can be dissolved in water. Both sodium carbonate and calcium chloride are water soluble.
However in relation to their water solutions, solid sodium carbonate and solid calcium chloride are much less stable, resulting ions becoming soluble.
Calcium carbonate forms a particular stable solid which will not dissolve in water. In this case the attraction of solid calcium carbonate is an ionic attraction between the calcium ions and the carbonate ions.
How can MAX GROW electronic water treatment system give a solution ?
MAX GROW increases the level of solvent capability water has in order to dissolve all the existing deposits that calcium carbonate has created. This is achieved by transmitting radio waves, in continuously changing frequencies. Through this transmission the energy of the ions is increased, as radiowaves carry an extremely low electricity load, which is enough to stimulate the cells and the development mechanisms of the plant. The charged ions become powerful enough to charge the ions that have created the deposits in pipelines, boilers, cooling towers etc. The constantly variable frequencies are programmed automatically, virtually every tenth of a second from the device itself based on a mathematic algorithm. This is the competitive advantage of MAX GROW advanced electronic water treatment system, compared to any other water treatment device that exists on the market.
MAX GROW system’s powerful advanced electronics transmit radio waves to both left and right hand side and in up to 30 meters distance to each side. Water is already being pre processed and its ions are charged with energy before it reaches the spot where the device is installed. Charged ions from MAX GROW remain in this form for up to 48 hours, although we have to mention that as time passes the power of the ions begin to fade. In order to avoid this phenomenon our company strongly suggests that MAX GROW should not be installed before water tanks or before any other spot that water may remain still for more than three days.
How does MAX GROW work?
It is very important to note that the device does not cause deterioration of the chemical composition of water, so it remains drinkable and chemical additives are not necessary to use. Installing “MAX GROW” does not require cutting the pipe or making any kind of alteration in the irrigation system and can be installed by unskilled person, as it is attached with high quality clamps which are placed on the pipe, wraping the wires left and right of the device using electrical adhesive tape. The device can also be mounted on a base or a wall close to the pipe. Since no alteration is required water pressure remains the same.
The device is available for 1,2,3,4,5 inch pipes up to 12 inches. In a nutshell, “MAX GROW” does not allow the salt to create sintering and accretion. It achieves the opening of the capillary vessels and dissolves the crust created at the surface and inside the ground. Most importantly it removes all existing scale deposits without the use of chemicals, filters etc.
The result is to have up to double crop production and excellent quality. Decomposition of salts leads to achieve rapid leaching of soil, thus reducing drastically the electrical conductivity of the ground, making the ground frothy. “MAX GROW” does not require filters or any form of servicing. The device does not have any interchangeable parts and is accompanied with a ten year written warranty.